Bosch 800 Series Manual de instruções de instalação - Página 8

Imprimir página

Bosch 800 Series Manual de instruções de instalação

WARNING

Avoid Electrical Shock Hazard!

Do not work on an energized circuit. Doing so could

result in serious injury or death. Only qualified

electricians should perform electrical work. Do not

attempt any work on the dishwasher electric supply

circuit until you are certain the circuit is de-energized.

WARNING

Avoid Fire Hazard!

Make sure electrical work is properly installed. Only

qualified electricians should perform electrical work.

Electrical Supply

The customer has the responsibility of ensuring that

the

dishwasher

electrical

compliance with all national and local electrical

codes and ordinances. The dishwasher is designed

for an electrical supply of 120V, 60 Hz, AC,

connected to a dishwasher-dedicated, properly

grounded electrical circuit with a fuse or breaker

rated for 15 amps. Electrical supply conductors

shall be a minimum #14 AWG copper wire rated at

75°C (167°F) or higher.

WARNING

Avoid Fire Hazard!

Make sure there are no loose electrical connections.

Make sure all electrical connections are properly made.

Grounding Instructions

The dishwasher must be properly grounded before

operating. This appliance must be connected to a

grounded metal permanent wiring system or an

equipment grounding conductor must be run with

the circuit conductors and connected to the

equipment grounding terminal or lead on the

dishwasher. Make sure that the dishwasher is

connected to a suitable ground in compliance with

all local codes or, in the absence of a local code,

with the NATIONAL ELECTRICAL CODE in the

United States or the CANADIAN ELECTRIC CODE

C22.1-latest edition in Canada as well as any

provincial/state or municipal or local codes that

apply.

Dishwasher Electrical Rating

Volts

Hertz

120

Electrical Preparation

installation

Amperes

Watts

1,300 (max)

Electrical Connection

The dishwasher electrical supply junction box (L)

and dedicated receptacle must be mounted in an

accessible cabinet adjacent to the dishwasher (do

not mount the junction box or receptacle behind the

dishwasher). You will need a 43/4 x 23/8 (120 x

60 mm) opening through the cabinet in order to

pass the junction box through (see Figure 5). If the

opening is made through wood, sand it smooth. If

the opening is made through metal, use the

included edge protector (G) or other approved

method to protect wiring from damage. Use the four

screws included (or appropriate fastener) in the

parts bag to securely mount the junction box so that

it can be easily accessed (see Figure 5). The

electrical supply can be connected in two ways:

Method A - Three prong plug and receptacle

Use the included three-prong plug and junction box

to connect to a dedicated household receptacle.

Make sure the household receptacle meets the

electrical supply requirements as well as national

and local codes.

Figure 5