Bosch DISHWASHER Manual de instruções de utilização - Página 23

Imprimir página

Bosch DISHWASHER Manual de instruções de utilização

Aqua sensor *

* on applicable models

The Aqua sensor is an optical measuring

device which measures the turbidity of the

rinsing water. A light barrier can detect

dissolved food remnants in the water, e.g.

egg, fat and oats.

The Aqua sensor is used according to

the programme. When the Aqua sensor

is active, "clean" rinsing water may be

transferred into the next rinsing bath

and/or the temperature adjusted. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In this

way the water consumption is reduced by

approx. 4 litres for utensils which are "less"

dirty.

Starting the programme

Before starting the appliance, check

again that the spray arms can rotate

freely.

In the main menu press the "Start"

button

"Close door" is displayed alternating with

the expected programme duration. This

time is only an approximate value. At the

start of the programme this time

corresponds to the running time which the

selected programme required last time.

While the programme is running, the

remaining running time is corrected based

on the water inlet temperature as well as

on the amount and degree of soiling of the

utensils.

If you have preselected a time for the start

of the programme, "Close door" is

displayed alternating with the preselected

time when the programme has started.

Close the door.

The programme or the preselected time

starts.

The programme and other settings can

still be changed for as long as the door is

open after the "Start" button

been pressed. Return to the main menu by

pressing the "Back" button and change the

settings. Finally, restart the programme.

If the door is closed after the "Start" button

has been pressed and the programme has

already started, the programme must be

terminated if settings are to be changed

(see "Terminating the programme").

Interrupting the programme

To interrupt the programme, open

the door. Open the door only slightly

to prevent water from spraying out of

the appliance.

"Terminate programme" is displayed

alternating with "Close door", the

remaining programme time, the

selected programme and the current

programme phase.

To interrupt the programme, NEVER press

the "Terminate programme" button

otherwise the programme cannot be

continued!

To continue the programme, close

the door. The programme continues

running automatically.

If there is a warm-water connection or

if the appliance has already been

heated, leave the door slightly open

for several minutes before closing it.

Otherwise, the door may spring open

again due to the hot air enclosed inside

the appliance.

. has