Bosch DISHWASHER Manual de Instruções - Página 18

Imprimir página

aus

Troubleshooting

The majority of faults which could occur in

daily operation can be rectified by the

user. This ensures that the appliance is

quickly available for use again. The

following overview will help you locating

the causes and gives helpful advise to

eliminate them.

Warning

If on the digital display 8 an error code

( :

to :

), always disconnect the

appliance from the power supply and then

turn off the tap.

You can rectify certain faults yourself (see

following fault description), for all other

faults please contact customer service and

state the indicated fault :XX.

Warning

Don't forget: Repairs may be carried out

by technicians only. If a component has to

be replaced, ensure that only original

spare parts are used. Improper repairs or

use of non-original spare parts may cause

considerable damage and put the user at

considerable risk.

... when the appliance is

switched on

The appliance does not start.

– The mains fuse has tripped.

– The appliance plug has not been

inserted.

– The appliance door has not been shut

properly.

... changing settings

A setting cannot be changed, a

programme starts.

– Wrong programme button pressed.

Terminate the programme (see chapter

entitled "Terminating the programme

(Reset)") and start all over again.

– You did not wait until programme

ended.

... on the appliance

Lower spray arm rotates sluggishly.

– Spray arm blocked.

The door is difficult to open. *

– Child-proof lock is activated. The

deactivation instructions are at the

back in the envelope.

* depending on model

Door cannot be closed.

– Door lock has been activated. To reset,

close the door with greater force.

Cover on the detergent dispenser cannot

be closed.

– Detergent dispenser overfilled or

mechanism blocked by sticky

detergent residue.

Detergent residue in the detergent

dispenser.

– Dispenser was damp when filled.

"Check water supply" display @ lights

up.

– Tap turned off.

– Water supply interrupted.

– Supply hose kinked.

– Filter in the water supply blocked.

– Switch off the appliance and pull

out the mains plug.

– Turn off the tap.

– Clean filter in the supply hose.

– Reconnect power supply.

– Turn on the tap.

– Switch on the appliance.