Bosch DWHD650GPR Manual de instruções de instalação - Página 8
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça Bosch DWHD650GPR. Bosch DWHD650GPR 40 páginas. Bosch evolution sge63e05uc: install guide
Imprimir página
1. Remove the dishwasher electrical supply junction box
cover and connect to the power supply cord from the
house installation. (see Figure 5).
2. Remove 2" to 3" (51 - 76mm) of the outer casing of the
Remove 3/8" to 1/2" (10 - 13mm) of the insulation from
each wire as shown in Figure 6.
3. Insert the bare copper or green wire(ground) to the
"G" ground connection "
and securely tighten the terminal block screw (see
Figure 5).
4. Insert the white (neutral) wire to the "N" connection of
the terminal block and securely tighten the terminal block
screw.
5. Insert the black(hot) wire to the "L" connection of the
terminal block and securely tighten the terminal block
screw.
6. Check all electrical connections to make sure they are
secure and then attach the junction box cover with the 4
screws.
WARNING
Avoid Electrical Shock Hazard
To avoid possible injury or property damage,
care should be exercised when the dishwasher is
installed or removed to reduce the likelihood of
damage to the power cord.
8
Figure 6
" of the terminal block
Hot Water Supply
The hot water heater should be set to deliver approximately
120° F (49° C) water to the dishwasher. Water that is too
hot can cause some detergents to lose effectiveness. Lower
water temperatures will increase run times. The hot water
Figure 6.
supply pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
sure to make all solder connections before connecting the
water supply line to the dishwasher.
·
Always use the appropriate seal when making plumbing
connections.
·
Before connecting the water supply line to the dishwasher,
to clear any foreign material.
·
Turn on the water supply and check for leaks after
connections are made.
Do not perform any work on a charged hot water
plumbers should perform plumbing work. Do not
attempt any work on the dishwasher hot water
supply plumbing until you are certain the hot water
Temperatures required for soldering and sweating
will damage the dishwasher. If plumbing lines
are to be soldered or sweated, keep the heat
source at least 6 inches (152.4 mm) away from
Inlet Water Connections
WARNING
Avoid Scald Hazard
supply is shut off.
the dishwasher.