Bosch FAP-OC 500Series Manual de serviço - Página 14

Figure 12 Bosch user interfaces

The user interface control board is assembled onto a chassis and the

entire assembly is serviced as a single unit.

4.8.1

Removing the User Interface

1. Slide unit out from wall ~ 4 inches.

2. Remove 2 T20 bolts from each side.

3. Grasp one corner of the interface panel and lift upward, then

pull it toward you (see Figure 13).

4. Repeat on the other side.

5. Disconnect the 3-wire yellow harness leading to PC control

module.

Each side of the user interface bracket has a tab

Figure 13

chassis u-profile

To remove the user interface board and chassis from the manifold

bracket, remove the 10 binding-head T20 screws securing the

interface chassis to the bracket (these screws are unique to the

interface – notice the serrated underside).

If the user interface assembly was difficult to remove, break the metal

tabs off ( ) to make it easier to reinstall; use pliers to bend the tabs

back and forth until they break off.

Service Manual for Bosch Built-in Wall Ovens

that rests in a slot on the

Page 14 of 36