Bosch SB Series Manual de instruções - Página 11

Imprimir página

1. Open the screw-type cap of the

compartment 1R.

2. Fill the tank with water (only required

when switching on the appliance for

the first time).

3. Then add dishwasher salt (not table

salt or tablets).

The water is displaced and runs out.

As soon as the salt refill indicator @

on the fascia is lit, top up the salt.

* depending on model

Using detergents with salt

component

D e t e r g e n t s w i t h s a l t c o m p o n e n t

If combined detergents with a salt

component are used, salt can usually be

omitted up to a water hardness of

21° dH (37° fH, 26° Clarke, 3.7 mmol/

l). If the water hardness is over 21° dH,

special salt must be used.

Switching off salt refill

indicator/water softening

system

S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m

If the salt refill indicator @ is impaired

(e.g. when using combined detergents

containing salt component), it can be

switched off.

Proceed as described under

"Adjusting the water softening

system" and set the value to :

The water softening system and salt

refill indicator are now switched off.

Caution

Never fill the salt dispenser with

detergent. You will destroy the water

softening system.

Rinse aid

R i n s e

As soon as the rinse-aid refill

indicator H is lit on the fascia, there

is still a rinse-aid reserve of 1-2 rinsing

processes. Refill with rinse aid.

The rinse aid is required for stain-free

utensils and clear glasses. Use only

rinse aid for domestic dishwashers.

Combined detergents with rinse-aid

component may be used up to a water

hardness of 21° dH (37° fH,

26° Clarke, 3.7 mmol/l) only. If

the water hardness is over 21° dH,

rinse aid must be used.

Rinse aid

a i d