Bosch SB Series Manual de instruções - Página 30

Imprimir página

en Operating the appliance

Remaining running time

display

When the programme is selected, the

remaining programme time is indicated

in the display window h.

*After the programme has started, the

remaining running time is displayed on

the floor (only for settings Timelight

†:‹‚ and †:‹ƒ).

The running time is determined during

the programme by the water

temperature, the quantity of dishes as

well as the degree of soiling and may

vary (depending on the selected

programme).

* depending on the features of your

dishwasher

Time preselection *

* depending on the configuration of

T i m e p r e s e l e c t i o n

your specific dishwasher

You can delay the start of the

programme in hourly steps by up to 24

hours.

Here's how to set up the delay:

Switch on ON/OFF switch (.

Press the timer programming button

P + repeatedly until h œ ‹‚

appears in the display window.

Keep pressing the timer

programming button P - or + until

the desired time is displayed.

Press START button `.

The delay timer has been activated.

To clear the specified delay, press

the button P - or + repeatedly until

h œ ‹‹ appears in the display

window.

Until the programme has started, you

can change your selection in any way

you like.

Programme end

The programme has finished when the

value ‹:‹‹ appears in the display

window h. If a value has been set for

the signal volume, then the end of the

programme is also indicated by a

buzzer.

Here's how to change the signal

volume:

Switch on ON/OFF switch (.

Hold down the programme button

# and then repeatedly press the

START button ` until •:‹...

appears in the display window.

Release both buttons.

The LED of the # button flashes

and the digital display h shows

the factory setting •:‹....

Press the programme button #

repeatedly until the factory setting

value ›:‹ƒ appears in the display

window h.

Press the programme button 3.

Each time the button is pressed the

set value increases by one level;

when it reaches the value ›:‹„ the

display jumps back to ›:‹‹ (off).

Press START button `.

The set value is saved.

* The end of the programme is

displayed n the floor (only for the

settings Timelight †:‹‚ and †:‹ƒ).

* depending on the features of your

dishwasher