Bosch SB Series Manual de instruções - Página 15

Imprimir página

Setting amount of rinse aid

You can set the amount of rinse aid that

should be added to a value between

§:‹‹ and §:‹‡. Setting the amount of

rinse aid to be dispensed to §:‹† will

give you a very good drying result. The

factory setting is §:‹†. Do not change

the amount of rinse aid unless there are

streaks or water stains on the utensils.

Set a lower level to avoid streaks. Set a

higher level to avoid water stains.

Here's how to set the amount of rinse

aid:

Switch on ON/OFF switch (.

Hold down the programme button

# and then repeatedly press the

START button P until •:‹...

appears in the display window.

Release both buttons.

The LED of the # button flashes

and the digital display )" shows

the factory setting •:‹....

Press the programme button #

repeatedly until the factory setting

value §:‹† appears in the display

window )".

Press the programme button 3.

Each time the button is pressed, the

set value increases by one level;

when it reaches the value §:‹‡ the

display jumps back to §:‹‹ (Off).

Press START button P.

The set value is saved.

Using detergent with a rinse

aid component

I n general, you can use detergent with

D e t e r g e n t w i t h a r i n s e a i d c o m p o n e n t

a rinse aid component up to a water

hardness level of 21 °dH (37 °fH, 26

°Clark, 3.7 mmol/L) without adding

rinse aid. Above a water hardness value

of 21 °dH, use additional rinse aid.

Switching off rinse aid refill

indicator

If the rinse aid refill indicator h

bothers you (e.g. if you are using a

combination detergent with a rinse aid

component), you can switch off the

rinse aid refill indicator.

Proceed as described under "Setting

rinse aid quantity" and set the level to

§:‹‹. The rinse aid refill indicator h is

switched off.

Rinse aid en