Bosch SB Series Manual de Instruções - Página 38

Imprimir página

Installation and connection

Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply

is connected.

Removing the appliance

Also observe

the sequence of worksteps here.

1. Disconnect the appliance from

the power supply.

2. Turn off the water supply.

3. Undo the waste water and drinking

water connection.

4. Loosen fastening screws for

the furniture parts.

5. If fitted, remove the base panel.

6. Pull out the appliance, carefully

pulling the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according to the

following steps:

1. Turn on the tap.

2. Open the door.

3. Switch on ON/OFF switch (.

4. Select programme with the highest

temperature.

The expected programme duration is

indicated on the numerical display

5. Press START button )".

6. Close the door.

Programme sequence starts.

7. Open door after approx. 4 minutes.

8. Press START button )" until :

is indicated on the digital display.

9. Close the door.

10. Open door after approx. 1 minute.

The numerical display indicates

11. Switch off ON/OFF switch (.

12. Turn off the tap, disconnect supply

hose and drain water.

Transport appliance upright only.

(This prevents residual water from

running into the machine control and

damaging the programme sequence.)

Protection against frost

If the appliance is in a room where there

is a risk of frost (e.g. holiday home),

empty the appliance completely (see

Transportation).

P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e )