Bosch SB Series Manual de instruções - Página 24

Imprimir página

Operating the appliance

Automatic switch off after end

of programme or interior light*

* depending on model

To save energy, the dishwasher can be

automatically switched off 1 min or 120

min after the programme ends.

The setting can be selected from :

to :

Appliance does not

switch off automatically.

The interior light 1"

comes on when the door

is opened irrespective of whether

the ON/OFF switch (

is switched on or off. When

the door is closed the light is off. If

the door is open for longer than 60

min., the light switches off

automatically. The interior light 1"

is lit only when the set value :

is selected.

Appliance switches off after 1 min.

Appliance switches off after 120

min.

1. Close the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button h

until : ... is indicated on the digital

display.

4. Release both buttons.

The LED for button # flashes

and the digital display )* displays

the factory setting :

5. Keep pressing programme

button # until the value : ... is

indicated on the numerical display

)*.

A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t

To change the setting:

1. Press programme button 3.

Each time the button is pressed,

the set value increases by one level;

when the value of :

reached, the display jumps back

to :

2. Press START button h.

The set value is saved.

Switching off the appliance

Short time after the end of the

programme:

1. Switch off ON/OFF switch (.

2. Turn off the tap (not applicable if

Aqua-Stop fitted).

3. Remove the utensils when they have

cooled down.

Note

When the programme ends, leave

the appliance to cool down a while

before opening it. This will prevent

steam from escaping and causing long-

term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave

the door ajar for several minutes and

then close. Otherwise, expansion

(pressure) may cause the appliance

door to spring open or water to run

out of the appliance.

2. To continue the programme, switch

on the ON/OFF switch ( again.

has been