Bosch SB Series Manual de instruções - Página 22

Imprimir página

Operating the appliance

Switching on the appliance

1. Turn on the tap fully.

2. Open the door.

3. Switch on ON/OFF switch (.

The Eco 50° programme display

flashes. This programme remains

selected if no other programme

button 0 is pressed. The expected

programme duration

flashes on the digital display 8.

4. Press the START button )".

5. Close the door.

The programme starts running.

Note

- for environmentally friendly operation

of the dishwasher:

For ecological reasons the Eco 50°

programme is preset whenever the

appliance starts. This conserves

environmental resources and not least

saves you money.

The Eco 50° programme is a

particularly environmentally friendly

programme. According to EU

regulation 1016/2010 it is the

"Standard programme" which is the

most efficient standard cleaning cycle

for cleaning normally soiled utensils in

terms of the combined energy and

water consumption for cleaning these

types of utensils.

Optical display while

the programme is running *

* depending on model

While the programme is running,

an optical display is indicated

on the floor under the appliance door.

If the base panel is pulled forwards

or if the appliance is installed at eye-

level with flush furniture front, the display

is not visible.

Possible settings of the optical

display:

The display is switched off.

Programme, timer programming,

remaining time, end of programme

and, if required, low water level are

displayed.

Same as :

information is also displayed,

e.g. the symbol for half load §

or glass protection system

active W.

is set at the factory.

To change the setting:

1. Open the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button )"

until : .... is indicated on the digital

display.

4. Release both buttons.

The illuminated display of the

button # flashes.

5. Keep pressing programme

button # until the previously set

value, e.g. :

digital display 8 : ... (for the

optical display).

6. Keep pressing programme

button 3 until the required value,

e.g. :

display 8.

7. Press START button )".

The set value is saved.

8. Close the door.

O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g

. Other programme

, is indicated on the

, is indicated on the digital