Installation of Rubber Drain Hose Adaptor
For a large port, use the drain hose as it is.
1. For a small port, insert the rubber drain hose adaptor
into the drain hose end.
2. Obtain the Rubber Drain Hose Adaptor (J) spring clamp
from the Dishwasher Installation Kit (do not substitute).
3. Insert the dishwasher drain hose into the end of the
drain hose (see Figure 15). Be sure to fully insert the
drain hose.
4. Use the clamp provided to attach the Rubber Drain Hose
Adaptor to the house plumbing as shown in Figure 16.
Figure 16
Installation of Mounting Brackets
Before installing the supplied countertop mounting
brackets, decide which method of securing the
dishwasher into its enclosure will be used. Once the
mounting brackets are installed on the dishwasher,
removing them is difficult and will damage the
mounting brackets and the dishwasher.
The dishwasher can be secured into its enclosure in 3 ways:
NOTE: If your dishwasher opening width measures >23
(600mm) use the TOP or SIDE MOUNT mounting methods.
If your dishwasher opening width measures 23
use the ALTERNATE SIDE MOUNT mounting method.
10
Figure 15
J
G
/
5
8
Top Mount is used for countertops made of wood or other
materials that can be easily drilled. Orient the mounting
brackets as shown in Figure 17, and position the two small
tabs on the mounting brackets over the two slots on the dish-
washer's front corners. Push the mounting brackets down
firmly to insert the tabs into the slots.
Top Mount
Figure 17
Side Mount is used for countertops made of marble, granite,
or other very hard materials that cannot be easily drilled.
Bend the mounting brackets along the small holes and in
the same direction as the two small tabs. Orient the mounting
brackets as shown in Figure 18, and position the two small
tabs on the mounting brackets over the two slots on the
dishwasher's front corners. Push the mounting brackets
down firmly to insert the tabs into the slots. Bend perforated
edge down as shown.
Side Mount
Figure 18
Alternate Side Mount for opening 23
a side mount force distributor (M) in each side as shown in
Figure 19.
/
"
5
8
" (600mm)
C
C
M
M
Figure 19
Alternate Side Mount
/
" (600mm). Insert
5
8
M
10
Imprimir página