Bosch SGS43T82 Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Máquina de lavar loiça Bosch SGS43T82. Bosch SGS43T82 18 páginas.

Imprimir página

Fresh water connection

Connect the fresh-water connection to

the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

When replacing the appliance, always

use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa ( 10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 1 0 litres/minute

Water temperature:

cold water preferred; hot water max.

temperature 60 °C.

Electrical connection

Connect the appliance only to 230 V

and 50 Hz alternating current via

a correctly installed socket with

protective conductor. See rating plate

for required fusing

lli3J.

The socket must be near the appliance

and freely accessible following

installation.

The connection may be modified by

technicians only.

A power cord extension may be

purchased from customer service only.

Use only a residual current operated

circuit-breaker which features

the symbol

!Bi!J.

Only this extension

guarantees compliance with

the currently valid regulations.

Removing the appliance

Also observe the sequence of worksteps

here.

Disconnect the appliance from the

power supply.

Turn off the water supply.

Disconnect the waste water and fresh

water connections.

Loosen the fastening screws under the

worktop.

If fitted, remove the base panel.

Pull out the appliance, carefully pulling

the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according

to the following steps:

Turn on the tap.

Close the door.

Select Eco programme

.:!£.

Switch on the main switch

[I].

The programme starts running.

Wait until approx. 4 minutes have

elapsed.

Rotate programme selector

to the Reset position.

After another minute

Switch off the main switch

[I].

Turn off the tap.

Transport appliance upright only.

(This prevents residual water from running

into the machine control and damaging

the programme sequence.)

Protection against frost

If the appliance is in a room where there is

a risk of frost (e.g. holiday home}, empty

the appliance completely (see

Transportation).

Turn off the tap, disconnect supply

hose and drain water.

Childproof lock (door lock)*

The description of the childproof lock is at

the back in the envelope.

* depending on model

Damage

The appliance may be repaired and

opened up by a technician only. To do

this, disconnect the appliance from the

power supply. Pull out the mains plug

or switch off the fuse. Turn off the tap.

Disposal

Make redundant appliances unusable

to prevent subsequent accidents.

Dispose of the appliance in an

environmentally friendly manner.

Warning

Children could become locked in the

appliance (risk of suffocation) or find

themselves in other dangerous situations.

Therefore: Pull out the mains plug, sever

and dispose of the power cord. Destroy

the door lock so that the door can no

longer be closed.

Before using your appliance for

the first time

Your appliance was tested before it left the

factory. To remove any remaining test

water, wash the first time without utensils

at the highest temperature. Pour salt, rinse

aid and detergent into the designated

filling orifices.