DragonTouch Vision 5 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Câmaras de ação DragonTouch Vision 5. DragonTouch Vision 5 13 páginas.

BATTERY STORAGE AND HANDLING

The camera contains sensitive components, including the battery. Avoid exposing your

camera to very cold or very hot temperatures. Low or high temperature conditions may

temporarily shorten the battery life or cause the camera to temporarily stop working

properly. Avoid dramatic changes in temperature or humidity when using the camera, as

condensation may form on or within the camera.

Do not dry the camera or battery with an external heat source such as a microwave oven

or hair dryer. Damage to the camera or battery caused by contact with liquid inside the

camera is not covered under the warranty.

Do not store your battery with metal objects, such as coins, keys or necklaces. If the

battery terminals come in contact with metal objects, this may cause a fire.

Do not make any unauthorized alterations to the camera. Doing so may compromise

safety, regulatory compliance, performance, and may void the warranty.

WARNING: Do not drop, disassemble, open, crush, bend, deform, puncture, shred,

microwave, incinerate or paint the camera or battery. Do not insert foreign objects into the

battery opening on the camera. Do not use the camera or the battery if it has been

damaged - for example, if cracked, punctured or harmed by water. Disassembling or

puncturing the battery can cause an explosion or fire.

VIDEO

To record Video, verify the camera is in Video mode.

Photo Button

Video Button

Splashproof only, not waterproof

To start recording:

Press and hold the video button for 5 seconds. The camera will emit one beep and the

amera light will flash while recording.

To stop recording:

Press and hold the video button for 5 seconds. The camera will emit one beep and the

camera light will stop flashing while recording.

PHOTO

To capture a photo, verify the camera is in Photo mode.

To take a photo:

Press the Red Photo Button. The camera will emit a camera shutter sound.

Note: Press the video button, the camera screen goes to sleep mode.

In sleep mode, press the video button, the camera screen wakes up.

CR2032 BATTERY REPLACEMENT FOR VISION 4 REMOTE

1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of the

remote, allowing you to open it.

2. Remove another 4 screws on PCB board.