1M2M ED1610 Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Acessórios 1M2M ED1610. 1M2M ED1610 3 páginas.

1M2M Click

Installation manual click version

Contents (see image 1):

1x ED16xx PCB, packed in an antistatic bag and stickers with the DEVEUI number and SIGFOX ID

1x small bag of Silica gel (do not open).

1x Batterypack (blue or black)

1x Enclosure (1 cover, 1 bottom and 1 click mounting plate)

1x Rubber seal (pre-mounted on the cover, only on non-vented covers)

There are different versions of the cover (Click Small, Click Large, Click Vented), all three are mounted the same

way, the only difference is that de vented cover does not need a rubber seal.

Assembly instructions:

1. Open the antistatic bag and put the DEVEUI/SIGFOX stickers on the

enclosure where it is legible.

2. Connect the battery as pictured (Image 2A for ED1608, Image 2B for

ED1610).

Note: please do this carefully and in the correct connector (J1).

Check: you will see a LED blink on the PCB.

3. Put the ED16xx PCB together with the battery pack in the enclosure.

Be sure the battery connector is facing up and towards the lid.

The PCB will fit into the two slits on the inside of the enclosure.

Check: on the top of the enclosure you will see the LED blink.

ED16xx

Installation manual 1M2M Click 17-04-2020 Page 1 of 3

Image 1

Image 2A

Image 2B

Image 3