Bosch 2 Manual de instruções original - Página 13

Imprimir página

1. Starting Operation

OBJ_BUCH-412-001.book Page 32 Thursday, April 3, 2008 3:18 PM

32 | English

Mount the angled screw head 3 onto the flange

in the requested position and tighten the sleeve

nut with the open-end spanner 4 via the spanner

flats 19. Hold the angled head flange with the

open-end spanner 6 to prevent turning.

ANGLE EXACT 14CF | 22CF | 29CF

On these industrial cordless angle wrenches, a

fitting flat drive has to be mounted first.

Different flat drives are available on the market.

Please inquire for the fitting flat drive at your

specialist shop.

Observe the mounting instructions of the

flat drive.

Suspension Device

With the utility clip 8, the machine can be at-

tached to a suspension device.

Fasten the utility clip 8 to the machine by engag-

ing it into the fastening slots 15.

Regularly check the condition of the utility

clip and the hook of the suspension device.

Charging Procedure

Note: Battery charger and battery packs are not

included in the delivery scope.

The power plug shown can vary from the one on

your power tool.

Please take care, that the charger and the

battery pack are suitable for your country

specific electricity network.

15 Minute Charger AL 15 FC (see figure A)

Plug the power plug 22 of the battery charger 21

into your electrical power supply outlet and in-

sert the battery 11 correctly into the charging

compartment of the battery charger.

Do not exert any force when inserting/re-

moving the battery. Batteries with APT con-

tact (Akku Pack Top) are designed in such a

manner that they can only be inserted into

the power tool or the charger in the correct

position.

The green LED indicator 23 starts to flash. This

indicates the flow of the charging current. The

charging process automatically stops when the

battery is fully charged.

3 609 929 B34 | (3.4.08)

The charging procedure is over when the green

LED indicator no longer flashes and lights up

uniformly.

An audible signal sounds for approx. 2 seconds

and signals that the battery is fully charged.

Continuous lighting of the red LED indicator 24

signals a charging procedure with reduced

charging current.

When the red LED indicator flashes, charging is

not possible.

1 Hour Charger AL 60 DV (see figure B)

Plug the power plug 22 of the battery charger 21

into your electrical power supply outlet and in-

sert the battery 11 correctly into the charging

compartment of the battery charger.

Do not exert any force when inserting/re-

moving the battery. Batteries with APT con-

tact (Akku Pack Top) are designed in such a

manner that they can only be inserted into

the power tool or the charger in the correct

position.

The green LED indicator 23 starts to flash. This

indicates the flow of the charging current. The

charging process automatically stops when the

battery is fully charged.

The charging procedure is over when the green

LED indicator no longer flashes and lights up

uniformly.

Continuous lighting of the green LED indicator

23 signals that charging is not possible.

Troubleshooting – Causes and Corrective

Measures

Cause

Corrective Measure

LED indicators do not light up

Mains plug of battery

Insert mains plug (ful-

charger not plugged in

ly) into the socket out-

(properly)

let

Socket outlet, mains

Check the mains volt-

cable or battery

age; have the battery

charger defective

charger checked by an

authorised after-sales

service agent for

Bosch power tools

Bosch Power Tools