Bosch 2 Manual do utilizador e instruções de instalação - Página 12

Imprimir página

Bosch 2 Manual do utilizador e instruções de instalação

1. Installation Instructions

en Installation instructions

The bottom edge of the appliance is identical to the

lower edge of the drilling template.

Ensure that there are no electrical wires, gas pipes

or water pipes in the area where holes are to be

drilled.

Drill holes with a diameter of 8 mm.

Drill the hole depth in accordance with the length of

the screws.

Insert the wall plugs flush with the wall.

Remove the angle bracket for the flue duct.

10.

Screw in two fastening screws with washers to ap-

prox. 5 mm.

11.

Attach and align the appliance.

12.

Mark the hole for the safety screw.

13.

Remove the appliance once more.

Attaching the appliance

Drill an 8 mm hole for the safety screw.

Insert the wall plugs flush with the wall.

Attach the appliance.

Screw in the safety screw with the washer.

You can also use the right or left hole opening.

Fitting the flue duct

To separate the flue duct sections, remove the ad-

hesive tape.

Remove the protective foil from both flue duct sec-

tions.

Note:

¡ To prevent scratches, lay paper over the edges

of the outer flue duct section to protect the sur-

face.

¡ The slots on the inner flue duct section should

point downwards.

Push one flue duct section into the other.

Insert the lower flue duct section into the brackets

on the left and right on the appliance.

Screw the upper flue duct to the sides of the fixing

bracket using 2 short screws.

Fit the grease filters.

To avoid causing damage, do not bend the grease

filters.

Fitting the filter cover

WARNING ‒ Risk of injury!

Components inside the appliance may have sharp

edges.

▶

Wear protective gloves.

Risk of injury from glass splinters.

▶

Protect the filter cover against impact.

▶

Do not drop the filter cover.

▶

Wear protective goggles during installation.

Align the filter cover at an angle of 90° to the appli-

ance.