Bosch 6 Series Manual de instruções de instalação e utilização - Página 9

Imprimir página

Bosch 6 Series Manual de instruções de instalação e utilização

Control panel model 2

Symbol

Explanation

Fan on/off

1-3

Fan settings

Intensive mode 1

Intensive mode 2

Fan run-on

Automatic mode

Metal grease filter saturation indicator

Activated charcoal filter saturation indicator

Light on/off/dimming

Setting the fan

Switching on

Touch the

symbol.

The fan starts at fan setting 2.

Selecting the fan setting

Touch symbol 1, 2 or 3 to set a different fan setting.

Switching off

Touch the

symbol.

Intensive setting

You can use the intensive setting if there is a large

build-up of odours and fumes/vapours.

Switching on

Touch the

After approx. 6 minutes, the extractor hood

Note:

automatically switches back to fan setting 3.

Switching off

If you want to end intensive mode before the preset

time expires, touch the symbol for the required fan

setting.

symbol.

Fan run-on time

Switching on

Touch the

symbol.

The fan will run at fan setting 1.

After approximately 10 minutes, the fan will switch itself

off automatically.

Switching off

Touch the

symbol.

This immediately stops fan run-on.

Automatic mode

Switching on

Touch the

symbol.

The fan will start at setting 2.

Touch the

symbol.

The optimum fan setting is set automatically using

the PerfectAir sensor.

Switching off

Touch

or any fan setting to switch off automatic

mode.

The fan switches itself off automatically if the PerfectAir

sensor detects no further change in the air quality in the

room.

Automatic mode can run for a maximum of 4 hours.

Sensor control

In automatic mode, the PerfectAir sensor in the

extractor hood detects the intensity of the cooking and

roasting odours. Depending on the setting of the

PerfectAir sensor, the fan automatically switches itself to

another fan setting.

Possible sensor settings:

Default sensitivity setting:

Lowest sensitivity setting:

Highest sensitivity setting:

If the sensor controller responds too strongly or not

enough, it can be changed accordingly:

Touch and hold the

switched off. The setting will be displayed.

The sensor controller setting can be changed by

touching symbols 1, 2, 3,

Take your finger off the

Operating the appliance

(fan setting 3)

„

(fan setting 1)

‚

(fan setting

†

symbol when the fan is

symbol.

)