Bosch Axxis WFL 2090 Manual de instruções de funcionamento, cuidados e instalação - Página 26
Procurar online ou descarregar pdf Manual de instruções de funcionamento, cuidados e instalação para Máquina de lavar roupa Bosch Axxis WFL 2090. Bosch Axxis WFL 2090 36 páginas. Axxis lavadora
Também para Bosch Axxis WFL 2090: Manual de instruções de utilização e cuidados (37 páginas), Instruções de utilização e de instalação (37 páginas), Manual de instruções de funcionamento, cuidados e instalação (36 páginas), (Inglês) Instruções de funcionamento (37 páginas)
Imprimir página
Installation,
Connection
and Transportation
Safety information
CAUTION
Avoid risk of injury!
The washing machine is heavy. Lift with caution.
CAUTION
Frozen hoses can tear/burst. Do not install the
washing machine outdoors or in an area
exposed to frost.
Be sure to observe all listed warnings and cautions.
These installation instructions are intended for use
by qualified installers. In addition to these
instructions the washer shall be installed:
-
In the United States, in accordance with the
National Electric Code, ANSI/NFPA70 ~ latest
edition/State and Municipal codes and/or local
codes.
-
In Canada, in accordance with the Canadian
Electric Code C22.1 ~ latest edition/State and
Municipal codes and/or local codes.
If the washing machine is stored in a room which
will be exposed to temperatures below the freezing
point, or if it is located in a cabin that is being shut
down for the winter, any residual water in the pump
or water inlet hose(s) must be drained.
To drain the pump refer to page 20.
To drain the water hose(s) refer to page 22.
Take care not to damage the washing machine.
Do not hold onto protruding parts (e.g. loading
door) when lifting.
In addition to the safety information listed here, the
local water and electricity supplier may have special
requirements.
In case of doubt, have the appliance connected by
an authorized technician.
26
Factory supplied equipment
There is a packet of accessory parts supplied
with your washer. Check to make sure that all the
accessory parts supplied for your model are there.
If any parts are missing contact your dealer
immediately.
Inside the drum:
-
Water supply hoses (cold and hot water).
Any dampness left inside the drum was caused by
the final testing which every washing machine is
subject to before leaving the factory.