Bosch Programme Table Manual de instruções - Página 8

Imprimir página

Bosch Programme Table Manual de instruções

What to do if ...

Water is leaking out.

– Attach/replace the drainage hose correctly.

– Tighten the screw connection of the supply hose.

No water supply.

– Start not selected?

Detergent not dispensed.

– Tap not turned on?

– Filter blocked? Clean the filter

– Supply hose kinked or trapped?

Washing machine door

– Safety function active. Wait approx. 2 minutes.

cannot be opened.

– Is Rinse Hold (without final spin) selected?

Programme does not

– Start selected?

start.

– Washing machine door closed?

Detergent solution is not

– Is Rinse Hold (without final spin) selected?

drained.

– Clean the detergent solution pump

– Clean the waste pipe and/or drainage hose.

Water not visible in the

– Not a fault - water below the visible area.

drum.

Unsatisfactory spin

– Not a fault - the unbalanced-load detection system has cancelled

result.

the spin cycle because of uneven distribution of the laundry.

Laundry wet/too damp.

Distribute small and large items of laundry evenly inside the

drum.

–

Reduced Ironing selected?

– Selected speed too low?

Spin cycle performed

– Not a fault - unbalanced load detection system adjusts the

several times.

imbalance.

Residual water in the

– Not a fault - the action of the care product is not affected.

compartment for care

– Clean the insert if necessary

products.

Odour formation in the

– Run programme

washing machine.

standard detergent.

Wash display lamp

– Too much detergent used? Mix 1 tablespoon of fabric softener

flashes. Foam may be

with ½ litre of water and pour into dispenser II (not for outdoor

coming out of the

and down-filled textiles!).

detergent drawer.

– Reduce the detergent dosage for the next wash cycle.

Intense noise formation,

– Are the appliance feet fixed?

vibrations and "walking"

Secure the appliance feet

during the spin cycle.

– Transportation safety devices removed?

Remove the transportation safety devices

instructions.

Noises during spin and

– Clean detergent-solution pump

drain cycles.

The indicator lights do

– Power cut?

not function during

– Fuses tripped? Reset/change the fuse.

operation.

– If the fault occurs repeatedly, call the after-sales service.

Programme sequence

– Not a fault - unbalanced load detection system adjusts

longer than usual.

imbalance by repeatedly distributing the laundry.

– Not a fault - foam detection system active - adds an additional

rinse cycle.

Detergent residues on

– Occasionally, phosphate-free detergents contain water-insoluble

the laundry.

residues.

– Select

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and remove the mains plug from the socket.

– Turn off the water supply and call the after-sales service

page 10.

page 3, 4.

page 10.

page 5.

page 9.

Cottons 90 °C without laundry. Use

Installation instructions.

Installation

page 10.

Rinse/

Spin or brush out the laundry after washing.

Installation instructions.

Washing machine

en Instruction manual