Bosch Series 4 Manual de instruções de instalação e utilização - Página 13

Imprimir página

Bosch Series 4 Manual de instruções de instalação e utilização

Electrical connection

Warning – Risk of electric shock!

Components inside the appliance may have sharp

edges. These may damage the connecting cable. Do

not kink or pinch the connecting cable during

installation.

The required connection data can be found on the

rating plate inside the appliance; to do this, remove the

metal mesh grease filter.

Length of the connecting cable: Approx. 1.20 m

This appliance complies with the EC interference

suppression regulations.

Warning – Risk of electric shock!

It must always be possible to disconnect the appliance

from the electricity supply. The appliance must only be

connected to a protective contact socket that has been

correctly installed.

The mains plug of the mains power cable must be

easily accessible after installation of the appliance. If

this is not possible, an all-pole isolating switch must be

integrated into the permanent electrical installation

according to the conditions of overvoltage category III

and according to the installation regulations.

The permanent electrical installation must only be wired

by a professional electrician. We recommend installing

a residual-current circuit breaker (RCCB) in the

appliance's power supply circuit.

Preparing the housing

The extractor hood must be installed on the lower

■

edge so that it is flush with the housing.

The housing must cover the entire cooking area.

■

The max. weight of the extractor hood is 15 kg.

■

Appliance dimensions and safety clearances

Take the appliance's dimensions into account.

■

Comply with the safety clearances.

■

If the installation instructions for the gas cooking

appliances specify a different distance, the largest

distance must always be provided for.

The surround must still be sturdy after the cut-outs have

been made.

To install the extractor hood in a surround, the extractor

hood must be provided with the following dimensions:

Width

500-3 mm (appliance width of 53 cm)

Width

700-3 mm (appliance width of 73 cm)

Depth

352-3 mm

Height

min. 160 mm (appliance with two motors)

Wall thickness

16 mm

All walls of the surround must be at least 15 mm

Note:

thick.

Extractor hood 53 cm wide, with one or two motors:

Extractor hood 73 cm wide, with one or two motors:

Bosch Series 4 Manual de instruções de instalação e utilização - Página 13

installation.

General information