Bosch Vision 800 Series Manual de instruções de instalação - Página 8
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar roupa Bosch Vision 800 Series. Bosch Vision 800 Series 28 páginas. Gas slide-in ranges
Também para Bosch Vision 800 Series: Manual de instruções de utilização (40 páginas), Dimensões e especificações (2 páginas), Manual de instalação (6 páginas), Manual de serviço (43 páginas), Manual de serviço (36 páginas)
Inlet Water Connections
Hot Water Supply
The hot water heater should be set to deliver approximately
120° F (49° C) water to the dishwasher. Water that is too
hot can cause some detergents to lose effectiveness. Lower
water temperatures will increase run times. The hot water
supply pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
sure to make all solder connections before connecting the
water supply line to the dishwasher.
· Always use the appropriate seal when making plumbing
connections.
· Before connecting the water supply line to the dishwasher,
to clear any foreign material.
· Turn on the water supply and check for leaks after
connections are made.
WARNING
Avoid Scald Hazard
Do not perform any work on a charged hot water
plumbers should perform plumbing work. Do not
attempt any work on the dishwasher hot water
supply plumbing until you are certain the hot water
supply is shut off.
Temperatures required for soldering and sweating
will damage the dishwasher. If plumbing lines
are to be soldered or sweated, keep the heat
source at least 6 inches (152.4 mm) away from
the dishwasher.
Water Supply Shut Off Valve
Install an easily accessible shut-off valve (not supplied) in
the hot water supply line, as shown in Figure 8. All solder
connections must be made before the water line is connected
to the dishwasher.
Connecting the Hot Water Supply
There are two plastic corrugated hoses that exit the back of
end, is the water supply hose to the dishwasher (the other
(76 x 45 mm) opening through the cabinet to pass the dish-
washer water supply line through toward the shut off valve.
8
/
3
4
8