Bosch WAA28167GB Manual de instruções - Página 8
Procurar online ou descarregar pdf Manual de instruções para Máquina de lavar roupa Bosch WAA28167GB. Bosch WAA28167GB 8 páginas.
![Bosch WAA28167GB Manual de instruções](/uploads/products/server2/1363844/1363844.png)
What to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
– Start not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
Programme does not
– Start selected?
start.
– Washing machine door closed?
Detergent solution is not
– Clean the detergent solution pump
drained.
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin
– Not a fault - the unbalanced-load detection system has cancelled
result.
the spin cycle because of uneven distribution of the laundry.
Laundry wet/too damp.
Distribute small and large items of laundry evenly inside the
drum.
– Selected speed too low?
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the
– Run programme Cottons 90 °C without laundry. Use standard
washing machine.
detergent.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and
Secure the appliance feet
"wandering" during the
– Transportation safety devices removed?
spin cycle.
Remove the transportation safety devices
instructions.
Indicator lamps do not
– Power cut?
function during
– Fuses triggered? Reset/change the fuses.
operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence
– Not a fault - unbalanced load detection system adjusts
longer than usual.
imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on
– Occasionally, phosphate-free detergents contain water-insoluble
the laundry.
residues.
– Select Rinse or brush the laundry after washing.
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
page 10.
page 10.
page 5.
Installation instructions.
Installation
Installation instructions.
11
Washing machine
Instruction manual
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions
before operating the washing machine.
en