Bosch WAE20060UC/01 Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Máquina de lavar roupa Bosch WAE20060UC/01. Bosch WAE20060UC/01 4 páginas.
Também para Bosch WAE20060UC/01: Manual (6 páginas)

Bosch WAE20060UC/01 Instruções de instalação
-The
washing machine is heavy. TO AVOID RISK OF INJURY lift with caution.
-Erozen
hoses can tear/burst. Do not install the washing machine outdoors or in an area
exposed to freezing conditions.
-- These installation instructions are intended for use by qualified installers. In addition to these
instructions, if installing the washing machine:
In the United States comply with the National Electric Code, ANSI/NFPA70 - latest
edition/State
and municil_al and/or local regulations.
In Canada comply with the Canadian Electric Code C22.1 - latest edition!provincial and
municipal and/or local regulations.
_lf the washing machine is located in a room which will be exposed to temperatures below
freezing, or if it is located in a cabin that is being shut down for the winter, any residual water
in the pump or water inlet hose(s) must be drained.
_Take
care not to damage the washing machine. Do not hold on to protruding parts
(e,g. door) when lifting.
--In addition to the safety information listed here, the local water end electricity supplier may
have
special requirements.
-If
in doubt, have the washing machine connected by an authorized technician.
--The
washer must not be stacked on top of the dryer. Serious injury and damage may result.
- Risk of personal injury or death. DO NOT stack a dryer on top of the washer without the use
of one of the stacking kit accessories listed in the dryer manual.
- Stability is important to prevent washer from moving excessively during usage.
- The installation area must be firm and level.
- Soft floors/floor coverings are not suitable.
Power cord
Drainage hose
F
_
,
_!_;!iiiiii
_
Water supply hoses for
hot water (red marking)
Water supply hoses for
cold water (blue
marking)
Covers
A
w
Wrench (according to model)
Elbow
used with drain hose
Depending
on the connection
- 1 hose clip ® 0.94" / 24mm - 1.57" / 40mm (commercially available) for connection of the
siphon -> page 4; Water connection.
Useful
tools
- Bubble level for levelling the water.
- Y-connector (can be optained from any hardware store) in case there is only a cold water
connection.
order no. WMZ 20450.
To protect the washer drum from shifting, do not remove transportation bolt assemblies prior
............................................................
to installing the washer on the pedestal.
I!
[]
[]
a = 39in. / 100cm (approx.)
d = 57in. / 145cm (approx.)
b = 57in. / 145cm (approx.)
e = 37in. / 95cm (approx.)
c = 33in. / 85cm (approx.)
f = 53in. ! 135cm (approx.)
Available commercially or from customer service:
- Longer supply hose 86 1/2 inches (2.2m approx.).
g = rain. 23in. / 60cm
h = max. 39in. / 100cm
II