Bosch wae28462gb Manual de instruções e instruções de instalação - Página 25

Procurar online ou descarregar pdf Manual de instruções e instruções de instalação para Máquina de lavar roupa Bosch wae28462gb. Bosch wae28462gb 36 páginas.

Imprimir página

Display

F:18

F:21

F:23

N flashes

Other displays

Faults and what to do about them.

Faults

Water is leaking from the

appliance.

The appliance is not filling

with water.

Detergent is not being dis-

pensed.

The washing machine

door cannot be opened.

The programme will not

start.

The water is not draining.

Water is not visible in the

drum.

The spin result is not sat-

isfactory.

Laundry is wet/too damp.

The spin cycle runs sev-

eral times.

Cause/remedy

Detergent solution pump blocked. Clean the detergent solution pump.

■

~ Page 22

The drain hose/drain pipe is blocked. Clean the drain hose on the siphon.

■

~ Page 23

Motor fault. Call the after-sales service!~ Page 27

■

There is water in the base trough; the appliance is leaking. Call the after-sales

■

service! ~ Page 27

Childproof lock is active; deactivate it.~ Page 18

■

Too much foam detected, a rinse cycle has been switched on ~ Page 19

■

Switch off the appliance, wait for five seconds and then switch it on again. If the

■

display appears again, call the after-sales service! ~ Page 27

Cause/remedy

Attach the drain hose correctly or replace it. ~ Page 32

■

Tighten the screw connection on the supply hose. ~ Page 31

■

Has the Start button been pressed?

■

Is the tap turned on? ~ Page 31

■

Could the filter be clogged? Clean the filter. ~ Page 23

■

Is the inlet hose kinked or trapped?

■

The safety function is activated. Cancel the programme? ~ Page 19

■

$ Rinse Stop (without final spin) selected?

■

Can the door only be opened by the emergency release? ~ Page 24

■

Has the Start button been pressed to pause the programme, or has the

■

Ready in time been selected?

Is the washing machine door closed?

■

Is D (childproof lock) activated? Deactivate. ~ Page 18

■

$ Rinse Stop (without final spin) selected?

■

Clean the detergent solution pump. ~ Page 22

■

Clean the drain pipe and/or the drain hose.~ Page 23

■

Not a fault – the water is below the visible area.

■

Not a fault – the unbalanced load detection system has interrupted the spin

■

because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum.

Has the additional programme setting p Easy Iron also been selected?

■

Is the selected speed too low?

■

Not a fault – the unbalanced load detection system is adjusting an imbal-

■

ance.

Faults and what to do about them.