Draper BMSM Manual de instruções de utilização - Página 6
Procurar online ou descarregar pdf Manual de instruções de utilização para Ferramenta eléctrica Draper BMSM. Draper BMSM 20 páginas. Bench mounted spindle moulder
Imprimir página
ADDITIONAL SAFETY INSTRUCTIONS
WARNING
For your own safety, do not operate your spindle
moulder until it is completely assembled and installed
according to the instructions....and until you have read
and understood the safety rules, assembly procedures,
adjustment procedures and maintenance etc.
1. STABILITY.
There may be a tendency for the spindle
moulder to tip over or move during certain cutting
operations, such as, working with extremely large
heavy panels or long heavy boards.
2. MINIMISE POTENTIAL ACCIDENTS.
Most accidents are caused by FAILURE TO
FOLLOW SET UP AND OPERATION INSTRUCTIONS.
Avoid awkward hand positions, where a
sudden slip could cause a hand to move into the
cutting tool. Never reach behind, or around, the
cutting tool with either hand to hold down the
workpiece, or for any other reason. DO NOT
PLACE FINGERS OR HANDS IN THE PATH OF THE
CUTTING TOOL.
3. Never reach under or over your machine when
operating or make any adjustments when it is
running.
4. Turn the spindle moulder 'OFF' and disconnect the
power supply when changing the cutting tool, or
making any adjustments.
5. Always maintain control of the workpiece. DO NOT
'LET GO' of the workpiece until the machine has
stopped.
6. When removing short workpieces, or cleaning up
around the table, be sure the router is switched
'OFF'.
7. Never turn the spindle moulder 'ON' before
clearing the table of all tools, wood scraps, etc.,
except the workpiece and related feed or support
devices for the operation.
8. When moving the spindle moulder, disconnect
power supply.
WARNING: Do not allow familiarity (gained from
frequent use of your spindle moulder) to become
commonplace. Always remember that a careless
fraction of a second is sufficient to inflict severe
injury.
9. MAKE SURE YOUR FINGERS DO NOT CONTACT
THE TERMINALS OF THE POWER PLUG when
installing or removing from the mains power
supply.
10. Do not attempt to remove excess material in one
pass.
11. Always feed against the cutter' s direction of
rotation.
12. Read and understand the instructions supplied
with the machine before attempting to use this
spindle moulder.
13. AVOID KICKBACK. Never stand directly behind the
workpiece. Under no circumstances use the mitre
guide with the fence, as a dangerous kickback may
result.
14. IF YOUR SPINDLE MOULDER MAKES AN
UNFAMILIAR NOISE OR IF IT VIBRATES
EXCESSIVELY, CEASE OPERATING IMMEDIATELY
UNTIL THE SOURCE HAS BEEN LOCATED AND THE
PROBLEM CORRECTED. sawing wood.
-
Do not use High speed steel (HSS) blades;
-
The push-stick or push block should always be
stored with the machine when not in use.
-
SAFE OPERATION
-
Use push-sticks or push blocks to feed the
workpiece past the cutter;
-
Use and ensure correct adjustment of the guard is
observed.
-
Use only cutters for which the maximum possible
speed is not less than the maximum spindle speed
of the tool and is suitable for the material to be cut.
-
When transporting the machine use only
transportation devices and never use guards for
handling or transportation.
- 5 -