FlexShade
®
Section 6 - Remote Controller
Scan code with your smart-
phone to view a playlist of
FlexShade
Recharge limit
®
setting videos.
These videos do not replace
the written instructions, but
offer valuable help.
Section 7 - 12 Volt Motor Initial Setup
PROGRAMMING
PROGRAMMING
BUTTON
BUTTON - RECESSED
Please Note: Programming buttons will face
down when shade is installed.
Exiting Sleep Mode
FlexShade Recharge battery motors do not come preprogrammed from Draper
Mode" to avoid accidental operation during shipping. It is necessary to "Wake" motor before operation and setup.
1. To "Wake" motor and exit Sleep Mode ensure motor is
installed and secured in mounting hardware.
2. Press programming
button
(P1)
and quickly release. Shade will move to
on motor size)
lower limit if preprogrammed.
3. The motor is now no longer in "Sleep Mode" and ready
for further setup unless preprogrammed by Draper.
Please Note: Remote will be locked if preprogrammed.
Pair Motor with Controller
1. Select channel on controller to be paired with motor.
2. Press and hold P1 button on motor until motor responds with 1 jog and 1 beep.
3. Within 4 seconds, press and hold Stop button on remote until motor responds.
Caution: Consult
Motor Response:
user manual for
information on
Approx.
selecting channel.
Motor is now in programming mode and ready for setting limits.
Recharge
15 Channel Remote
Press right button for 1 second or less to display current mode.
RESPONSE
LCD displays "L" when locked
LCD displays "U" when unlocked
Enter Sleep Mode
(button or recessed based
To put motor back into
Sleep Mode, press and
hold programming
button for 6 seconds, 2
jogs and 2 beeps.
Motor Response:
Approx.
FRONT
LCD SCREEN
UP
STOP
DOWN
CHANNEL
SLIDE CONTROL
15 Channel
unless specified on order. Upon leaving factory each motor is placed into "Sleep
®
(P1)
Check Motor Direction
To check travel direction of shade,
press UP or DOWN on controller.
Quick Press = Step
Long Press = Continuous Travel
Important: Damage to shade may
occur when operating motor prior to
setting limits. Attention should be given.
5
BACK
P2
+
+
Battery Compartment
(Shown with cover removed)
1 Channel Remote
RESPONSE
LED solid on when locked
LED blinking when unlocked
JOG
1
X
To reverse shade direction,
hold both UP and DOWN.
Approx.
Important: Reversing motor
5
direction using this method
SECS
is only possible during initial
set-up.
5
SECS
5
SECS
5
SECS
5
SECS
SECS
page 5 of 11
Approx.
6
SEC
Motor Response:
BEEP
2
X
JOG
1
X
5
SECS
5
5
SECS
SECS
Imprimir página