Draper FlexShade NEXD Instruções de instalação e funcionamento - Página 7

Procurar online ou descarregar pdf Instruções de instalação e funcionamento para Mobiliário de interior Draper FlexShade NEXD. Draper FlexShade NEXD 10 páginas. Clutch-operated small and large hardware
Também para Draper FlexShade NEXD: Instruções de instalação e operação (6 páginas), Instruções de instalação e funcionamento (8 páginas), Manual de instruções (8 páginas), Instruções de instalação e funcionamento (8 páginas), Manual de instruções (12 páginas)

Draper FlexShade NEXD Instruções de instalação e funcionamento
Bottom-Up FlexShade
Small and Large Hardware

Section 9 - Adjusting Fabric Tracking

1. Slide both ends of the draw cable close to the
attachment stud flat washers.
2. Raise the shade to its fully closed position and
ensure that the hem bar is centered in the window.
3. Lower the shade to its fully retracted position.
4. Move one or both of the Draw Cable Attachment
Studs to the left or right so that each run of the
Draw Cable is hidden behind the front section of
the cable.
5. Observe the tracking on the fabric roller.
6. Adjust the tracking by loosening the smaller screw,
and then raising or lowering the fabric roller with
the larger screw, as needed
(Fig. 9-A)
7. Tighten the smaller screw to lock the position of
the roller.
8. Re-test the fabric tracking and re-adjust if needed.
9. Ensure that the hem bar does not contact
the fabric bundle, operator roller, pulleys, etc.
throughout its range of operation.
10. Trim any excess draw cable from both ends.
11. Click the hem bar pulley caps into place
Section 10 - Attaching Fascia
Figure 10
STEP 1:
STEP 2:
NEXD,
®
.
WARNING: Installer must ensure
that the cable is properly routed
.
(Fig. 9-B)
through the pulleys before the
pulley caps are installed. Pulley
caps are required for safety.
(Top Roller)
STEP 1:
Fascia seats
on projections
on endcaps.
1.
Loosen smaller
screw to
adjust
tracking.
STEP 1:
STEP 2:
Click fascia
into place
page 7 of 10
Figure 9-A
2.
Raise or lower
fabric roller
with larger
screw.
Figure 9-B
!
Fascia is not fully
seated until it
clicks into place
on both ends.
Once in place,
check for
secure fit.