Draper 56490 Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Lixadeira Draper 56490. Draper 56490 20 páginas. 230v mini belt sander

Imprimir página

ASSEMBLY

8.2 FITTING OR REPLACING THE

SANDING BELT – FIGS.5 – 7

Warning! Always ensure that the machine is

disconnected from its power source before

attempting to change or replace the sanding belt.

– Pull the belt release lever

above the belt tracking control knob

upwards to release the tension on the belt.

(Fig.5)

– Slide out the belt

– Refit the required belt over the rear roller

of the sanding arm

sanding head

Note: Always ensure that the direction of rotation

arrows found on the inside of the belt match the

direction of rotation arrow found on the body of the

machine.

– Return the belt release lever

position.

8.3 SANDING BELT TRACKING AND

ADJUSTMENT – FIG.8

Warning! Always wear the appropriate eye safety

protection when carrying out this procedure.

– Plug the machine back into the power supply

and operate the sander while observing the

belt.

– The new belt will have a tendency to track more

to one side. To centre the belt on the rollers and

over the sanding base, rotate belt tracking

control knob

slightly causing the belt to track across the

roller. Only slight adjustments are needed.

When the belt runs centrally on the rollers it is

adjusted correctly.

(located just

to be replaced.

and the roller on the

(Fig.6).

to its original

. This pivots the front roller

)

FIG.5

FIG.6

FIG.7

FIG.8

- 12 -