Drawmer DS301 Manual do operador - Página 14

Procurar online ou descarregar pdf Manual do operador para Amplificador Drawmer DS301. Drawmer DS301 20 páginas. Dual midi expander gate

MIDI PARAMETERS PROGRAMMING

The DS301 is equipped with a MIDI In socket and a MIDI Out which merges any

MIDI data generated by the DS301 with incoming MIDI data. Each audio channel

may be set up to respond to a different MIDI note (or notes), each audio channel

can send a different MIDI note, and these notes may be on different MIDI

channels if required.

To set the basic MIDI parameters, the audio channel being changed must be

switched to the MIDI trigger position at the Key Source switch. A MIDI keyboard

or other suitable controller should be connected to the MIDI In socket. This MIDI

keyboard / controller should be set to transmit on the MIDI channel that you wish

the DS301 audio channel to respond to.

PROGRAMME METHOD 1

If it is only required to set the MIDI note (and its channel) that will be output when

the DS301 is triggered by an audio signal, or that the DS301 will respond to when

triggered via MIDI, the procedure is:-

Hold down the Test/MIDI button for one second, (with NO MIDI data), the

trigger LED will flash slowly. Play the note on the keyboard, then release

the button. The DS301 is now set to generate and trigger from that note

and channel, whenever the envelope is fired.

PROGRAMME METHOD 2

If it is required to set the MIDI note (and its channel) that will be output when the

DS301 is triggered by an audio signal, and set a split range of notes that the

DS301 will respond to when triggered via MIDI, the procedure is:-

Hold down the Test/MIDI button for one second, (with NO MIDI data), the

trigger LED will flash slowly. Play the first note on the keyboard, the trigger

LED will now flash more quickly. This is the note that will be sent when the

envelope is fired. Still holding down the MIDI button, pressing a second

key defines the other limit of the split range of notes that will trigger the

gate from MIDI.

PROGRAMME METHOD 3

If it is required to set the MIDI note (and its channel) that will be output when the

DS301 is triggered by an audio signal, and set a split range of notes that the

DS301 will respond to when triggered via MIDI that is not bounded by the MIDI

output note, the procedure is:-

Hold down the Test/MIDI button for one second, (with NO MIDI data), the

trigger LED will flash slowly. Play the first note on the keyboard, the trigger

LED will now flash more quickly. This is the note that will be sent when the

envelope is fired. Still holding down the MIDI button, pressing a second

key defines the first limit of the split range. The trigger LED will flash very

quickly. Still holding down the MIDI button, pressing a third key defines

the other limit of the split range of notes which defines a note range that

will trigger the gate from MIDI. After receiving the third note the trigger

LED will extinguish.

If only one note is desired to trigger the gate, then the second and third notes

played should be made the same.

-12-