Bosch 6 Series Manual de instruções - Página 11

Imprimir página

Removing the grill heating element

The grill heating element can be removed in some ovens to

facilitate cleaning.

Risk of burns.!

The oven must be cold.

Pull the grill element handle towards you and push it upwards

until you hear it click into position (figure A).

At the same time, hold the grill element and swing it down

(figure B).

After cleaning, push the grill heating element up again. Push

the locking handle down and secure the grill element.

Removing and refitting the wire shelves or left

and right hand side rails

The wire shelves or left and right hand side rails can be

removed for cleaning. The oven must be cold.

Release the guides or rails

Lift the front of the guide or rail and release it (figure A).

Then pull the guide or rail forwards completely and remove it

(figure B).

Clean the guides or rails with detergents and a sponge. The

use of a brush is recommended for stubborn stains.

Install the wire shelves or rails

First insert the shelf or the rail in the rear groove by pushing it

back slightly (figure A)

then insert it in the front groove (figure B).

Wire shelves or rails can be adjusted on the left and right hand

side. Their curvature should always be face down.

Unhooking and hanging the oven door

The front panel can be unhooked to help remove the oven door

and clean the glass panels.

The oven door hinges are fitted with a locking lever. The door

cannot be unhooked if the locking lever is closed (figure A).

Once the locking lever has been opened to unhook the door

(figure B), the hinges will be locked in position. This prevents

the door from suddenly closing.

Risk of injuries.!

The hinges may close suddenly if they are not locked in

position by the lever. Note that the locking levers are always

closed, apart from when unhooking the door, when the levers

must be open.

Unhooking the door

Fully open the oven door.

Remove both locking levers located on the right and left hand

sides (figure A).

Fully close the oven door as far as possible (figure B). Grip

the left and right hand sides of the door with both hands.

Close the door slightly more and remove it.

Hanging the door

Rehang the door by following the same steps but in reverse

order.

When refitting the door, check that both hinges are

positioned exactly inside their respective openings (picture

A).

The bottom groove of the hinges must fit snugly on both

sides.

The door may be left crooked if the hinges are not mounted

properly.