Bosch 8 Series Manual do utilizador e instruções de instalação - Página 26

Procurar online ou descarregar pdf Manual do utilizador e instruções de instalação para Forno Bosch 8 Series. Bosch 8 Series 32 páginas. Combi steam oven
Também para Bosch 8 Series: Manual de instruções de instalação (21 páginas), Instruções de montagem (4 páginas), Manual de instruções de instalação e utilização (16 páginas), Manual de referência rápida (2 páginas), Manual do utilizador e instruções de instalação (44 páginas), Começar a trabalhar (7 páginas), Manual de instruções (32 páginas), Manual do utilizador e instruções de instalação (32 páginas), Manual de instruções (12 páginas), Manual do utilizador e instruções de instalação (24 páginas), Manual do utilizador (28 páginas), Manual do utilizador e instruções de instalação (28 páginas), Manual de instruções de instalação e utilização (20 páginas), Manual do utilizador e instruções de instalação (44 páginas), Manual de instruções (12 páginas), Manual do utilizador e instruções de instalação (40 páginas), Informações de utilização (20 páginas), Manual de instruções (48 páginas)

Imprimir página
Bosch 8 Series Manual do utilizador e instruções de instalação
en Installation instructions
19  Installation instructions
Observe this information when installing the appliance.
19.1 Scope of delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
 19.2 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be temperature-resistant
up to 90 °C, and adjacent unit fronts up to
65 °C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
26
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
▶ If the power cord is too short, contact cus-
tomer service.
19.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. The minimum installation height is
850 mm.
Ventilation slots and intake openings must not be
covered.
19.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
WARNING ‒ Danger: Magnetism!
The appliance contains permanent magnets. These
may affect electronic implants, e.g. heart pacemakers
or insulin pumps.
Persons with electronic implants must stay at least
▶
10 cm away from the appliance.
WARNING ‒ Risk of fire!
The use of multi-plugs, multiple connectors or exten-
sion cables may cause a fire.
Never use multi-plugs, multiple connectors or exten-
▶
sion cables.
¡ The appliance is fitted with a plug and must only be
connected to a protective contact socket which has
been correctly installed.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to local regulations.
¡ A socket must only be installed by a qualified elec-
trician, and in accordance with the appropriate regu-
lations.
¡ If the plug is no longer accessible following installa-
tion, an all-pole isolating switch with a contact dis-
tance of at least 3 mm must be present.