Bosch 800 Series Manual de instalação - Página 10

Imprimir página

Side View Gas Cooktop Installation

Arrow on the back of

the pressure regulator

shows the direction of

gas flow.

Gas and Electrical Location

Rough-in Cooktop Box

Arrow on Pressure Regulator

Pressure Regulator

1/2" Female Pipe Threads

Flexible Gas Line

Power Cord (60 inches/1,524mm)

120 Volt Receptacle

Gas Cut-off Valve

Gas Supply Line Stub-out

Floor

Connect the gas supply line to the unit pressure

regulator using a 1/2" flex gas line connector between

manual shut-off valve and pressure regulator. Always use

a new flex line.

Check supply line connections for leaks using a soap

solution or non-corrosive leak detection fluid. Do not use

a flame of any sort.

Turn on gas.

Apply a soap solution or non-corrosive leak detection

fluid to all joints and fittings in the gas connection

between the shut-off valve and the cooktop. Include

gas fittings and joints in the cooktop if connections

may have been disturbed during installation. Bubbles

appearing around fittings and connections indicate a

leak.

If a leak appears, turn off supply line gas shut-off valve

and tighten connections.

Retest for leaks by turning on the supply line gas shut-

off valve. When leak check is complete (no bubbles

appear), test is complete.

Wipe off all soap solution or detection fluid residue.

Important Notes for Gas Connection:

The appliance and its individual gas shutoff valve must

▯

be disconnected from the gas supply piping system

during any pressure testing of that system at test

pressures in excess of 1/2 psi (3.5kPa).

The appliance must be isolated from the gas supply

▯

piping system by closing its individual manual shut-off

valve during any pressure testing of the gas supply

piping system at test pressures equal to or less than

1/2 psi (3.5kPa).

Connect Electrical Supply

Before connecting the 5-foot (1.5m) supply cord to a wall

receptacle, make certain that gas shut-off valve and all

burner controls are in OFF position.

Burner Cap and Burner Base Placement

WARNING

To prevent flare-ups, do not use the cooktop without

all burner caps and all burner grates properly

positioned.

WARNING

To prevent burns, do not touch burner caps or

grates while hot. Turn the cooktop off and allow the

burners to cool.

The burner caps must be properly placed for the cooktop

to function properly. If the burner cap is not properly

placed, one or more of the following problems may

occur:

Burner flames are too high.

▯

Flames shoot out of burners.

▯

Stainless steel discolors.

▯

Burners do not ignite.

▯

Burner flames light unevenly.

▯

Burner emits gas odor.

▯