Bosch 800 Series Manual de utilização e cuidados - Página 7

Imprimir página

Bosch 800 Series Manual de utilização e cuidados

Operating the appliance

These instructions apply to several appliance models. It

is possible that individual features are described that do

not apply to your appliance.

Note: Turn the extractor hood on when you start cooking

and switch it off again a few minutes after you have

finished cooking. This is the most effective way to

eliminate cooking vapor.

Control panel

Explanation

Turn the fan down

Turn the fan up

Display panel

Switch on lighting

Timer

Turn on the fan

Note: Always adjust the fan strength to meet current

conditions. If there is a large build-up of steam or fumes,

select a high fan setting.

Switching on

Press "+" button.

▯

The current ventilator settings are indicated by a bar

on the display panel.

Press "+" or "-" keys to change the ventilator settings.

▯

Switching off

Press the "-" button repeatedly until the ventilator

switches off.

Lighting

The lighting can be switched on and off independently of

the ventilation.

Press the "Light" button.

The lighting switches on.

Press the "Light" button again.

The brightness increases.

Press the "Light" button a third time.

The lighting switches off.

Saturation notification

The saturation of the metal grease filter (after 30 hours of

ventilation operation) or of the activated carbon filter

(after 120 hours of ventilation operation) is indicated on

the display panel:

Metal grease filter: "clean grease filter" appears on

▯

the display panel.

Activated carbon filter: "replace charcoal filter"

▯

appears on the display panel.

If you have not yet done so, the metal mesh grease filters

should be cleaned or the activated carbon filter changed

now.

For instructions on how to clean the metal grease filters,

please refer to the Cleaning and maintenance section.

Resetting the saturation displays

Metal grease filter: Press and hold the "+" button for 5

▯

seconds.

Activated carbon filter: Press and hold the "-" button

▯

for 5 seconds.

Switching over the display for circulating-air mode

For circulating-air mode, the electronic control display

must be switched over accordingly:

The extractor hood must be connected and switched

▯

off.

Press the "+" and "-" keys simultaneously until "Able"

▯

lights up briefly on the display panel.

Repeatedly press the button combination to switch the

▯

electronic control display back to exhaust air mode.

"None" appears on the display panel.

Timer

The timer has no influence on the functions of the

exhaust hood. The duration of the timer can be set to

between 1 minute and 60 minutes. The default setting is

10 minutes.

Press the "Timer" button.

10 flashes on the display panel.

Set the required duration with the "+" and "-" buttons.

After 5 seconds, the time that has been set is adopted.

An audible signal sounds once the time has elapsed

and "End" appears on the display panel for 3 seconds.

Note: To switch off the timer earlier, press any button.

Fan back flow

The run-on time is ten minutes and cannot be changed.

Select ventilator setting.

Press "Timer" button for 3 seconds.

Once this time has elapsed, the ventilation and lighting

switch off automatically. The display shows the message

"End."

The ventilator run-on can be interrupted at any time by

pressing one of the buttons.

Audible signal

Switching on audible signal

Press and hold the "Light" button for 5 seconds.

▯

An audible signal sounds and "Snd" appears on the

▯

display panel for 3 seconds.