Bosch 800 Series Manual de instalação - Página 10

Adapting microwave blower

This microwave is shipped assembled for Room Venting

Installation. The blower unit is already in place and must

not to be adapted.

Adapting microwave blower for roof venting

Remove and save the screws holding the blower

motor and the blower plate. Lift up the blower plate

and put it aside.

Carefully pull out the blower unit and rotate 90º so that

fan blade openings are facing out the top of the

microwave.

Place the blower unit back into the opening.

CAUTION

Do not pull or stretch the blower unit wiring. Make

sure the wires are not pinched, and that they are

properly secured.

Replace the blower plate and secure with the screws

removed in step 1.

Attach the exhaust adapter to the top of the blower

plate by sliding it into the guides. Push in securely until

it is in the locking tabs. Make sure the damper hinge

swings freely.

Adapting microwave blower for wall venting

Remove and save the screws holding the blower

motor and the blower plate. Lift up the blower plate

and put it aside.

Carefully pull out the blower unit and rotate 90º so that

fan blade openings are facing out the top of the

microwave.

Rotate the blower unit counterclockwise 180º.

Gently remove the wires from the grooves. Reroute the

wires through the grooves on other side of the blower

unit. Rotate blower unit 90º so that fan blade openings

are facing out the back of the microwave.

CAUTION

Do not pull or stretch the blower unit wiring. Make

sure the wires are not pinched, and that they are

properly secured.

Place the blower unit back into the opening.