Bosch 800 Series Manual de instalação - Página 6

Imprimir página

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

The circuit breaker should have a contact separation of

at least 3 mm on all poles.

Installer – show the owner the location of the circuit

breaker or fuse. Mark it for easy reference.

Refer to rating label for more information. See "How to

Obtain Warranty Service" under "Customer Service" for

rating label location.

Gas Safety

Install a gas shutoff valve near the appliance. It must be

easily accessible in an emergency.

Leak testing must be conducted by the installer

according to the instructions in this manual.

The appliance and its individual shutoff valve must be

disconnected from the gas supply piping system during

any pressure testing at pressures in excess of ½ psi

(3.5 kPa).

The appliance must be isolated from the gas supply

piping system by closing its individual manual shutoff

valve during any pressure testing of the gas supply

piping system at test pressures equal to or less than

½ psi (3.5 kPa).

The minimum supply pressure must be 1" water column

above the manifold pressure printed on the rating label.

The maximum supply pressure must not exceed

14.0 inches water column (34.9 Millibars).

A metal flex line or fixed metal pipe shall be used to

connect gas to the appliance. If a metal gas line cannot

be used, consult your local certified electrician or local

electric codes for proper grounding.

IMPORTANT SAFETY NOTICE: Burning gas cooking fuel

generates some by-products which are on the list of

substances which are known by the State of California to

cause cancer or reproductive harm. To minimize

exposure to these substances, always operate this unit

according to the instructions contained in this booklet

and provide good ventilation.

Proposition 65 Warning:

This product may contain a chemical known to the State

of California, which can cause cancer or reproductive

harm. Therefore, the packaging of your product may

bear the following label as required by California:

Propane Gas Installation

The propane gas tank must be equipped with its own

high pressure regulator. In addition, the regulator

supplied with this unit must also be used.

The appliance is shipped from the factory for use with

natural gas. It must be converted for use with propane. A

qualified technician or installer must do the conversion.

This appliance has been certified for safe operation up to

a height of 10,000 ft. Exception: To use it with propane

gas, the appliance must be converted in accordance with

the propane conversion instructions.

For Massachusetts installations:

Installation must be performed by a qualified or

▯

licensed contractor, plumber or gas fitter qualified or

licensed by the state, province or region where this

appliance is being installed.

Shut-off valve must be a "T" handle gas cock.

▯

Flexible gas connector must not be longer than

▯

36 inches.

Installer - show the owner where the gas shut-off valve is

located.

Related Equipment Safety

The appliance should only be used if installed by a

qualified technician in accordance with these installation

instructions and all applicable regulations and codes.

The manufacturer is not responsible for damages

resulting from incorrect installation.

Remove all tape and packaging before using the

appliance. Destroy the packaging after unpacking the

appliance. Never allow children to play with packaging

material.

Never modify or alter the construction of the appliance.

For example, do not remove leveling legs, panels, wire

covers or anti-tip brackets/screws.

To eliminate the risk of burns or fire by reaching over

heated surface units, cabinet storage space located

above the surface units should be avoided. If cabinet

storage is to be provided, the risk can be reduced by

installing a hood that projects horizontally a minimum of

5 inches (127 mm) beyond the bottom of the cabinet.

Verify that cabinets above the cooktop are a maximum of

13" (330 mm) deep.

When installing a cooktop over a single oven, be sure to

follow both the oven's and cooktop's installation

manuals.

Ventilation Recommendations

We strongly recommend the installation of a ventilation

hood above this appliance. The hood must be installed

according to instructions furnished with the hood.

CAUTION

The appliance should not be installed with a ventilation

system that blows air downward toward the burners. This

type of ventilation system may cause ignition and

combustion problems with the gas cooking appliance

resulting in personal injury or unintended operation.