Bosch 800 Series Manual de serviço - Página 19

Imprimir página

Tuck insulation up into the oven wall as necessary.

While holding element terminals, lift element upward to clear

the outer edge of the compartment.

Hold element on both sides and lift upward as you slide it

straight out.

4.13.2

Reinstalling the Bake Element

There are 2 tabs inside the element cavity, and the front tab will

prevent the element from going in all the way. Use a ruler or the

vertical air channel (after removing plastic purse locks) as a tool to

guide the element back in.

1. Place the tool inside the cavity, on top of the tab, then insert

the element on top of the tool and slide it in.

2. After the element is beyond the front tab, remove the tool.

3. Complete the installation.

4. Replace the plastic purse locks clips if they were removed

from the vertical air channel.

4.14

Cooling Fan Motor (Upper Oven)

Each 2-speed cooling fan (120V 28/41W) has 3 terminals (high

speed, low speed, and neutral) and a Hall effect sensor. There is tape

around the motor windings and the terminals are labeled N, H, and L

for reference, as shown in Figure 18.

Figure 18 Tape on cooling fan windings marked to designate terminals

If the Hall effect sensor does not detect fan rotation, an error will

display. To test the upper fan at the control module, check voltage

across X105 / Pin 3 or 4 and neutral.

1. Remove 3 T20 screws securing the fan to the mounting

bracket.

2. Remove 3 T20 screws securing the bracket to the oven

housing.

3. Slide bracket up and out to release it from the 2 tabs holding it

in position.

4. Remove 3 T20 screws from the right side of the unit's top

panel.

5. Lift the right corner of the top panel and remove the fan/motor.

ERROR CODES

A Service Guide with error code information, wiring diagrams, and

instructions for entering Service mode (if applicable) is packed with

every unit. Find it on the underside of the upper plenum access panel

as shown in Figure 19.

Figure 19 Location of Bosch Built-in Oven Service Guide

5.1

Error Code Table

The following table is included in the oven Service Guide. The error

codes which begin with E2 apply to the lower cavity of double ovens.

Diagrams referenced in the table can also be found in the appropriate

Service Guide.

Service Manual for Bosch Built-in Wall Ovens

Page 19 of 36