Bosch Benchmark Series Manual de serviço - Página 13
Procurar online ou descarregar pdf Manual de serviço para Forno Bosch Benchmark Series. Bosch Benchmark Series 36 páginas. Built-in wall ovens
Também para Bosch Benchmark Series: Manual de instalação (32 páginas), Manual de referência rápida (4 páginas), Manual de serviço (45 páginas), Manual de instruções de instalação (40 páginas), Manual de início rápido e de segurança (13 páginas)
Imprimir página
58300000187895 ARA EN A
7
SERVICE AND REPAIR: OVEN
CAUTION
Turn off the electrical power circuit to the range at the main
junction box before servicing this unit.
For those checks requiring the use of electrical power, exercise
extreme care.
Sheet metal parts often have sharp edges. Avoid injury by
handling these parts with care.
7.1
Doors
The serviceable parts of the QuietClose™door include the handle,
endcaps, outer door glass/skin (service assembly), hinges (service kit
with one dampen hinge and one spring hinge), middle glass, 2-pane
glass pack, porcelain-coated door liner, and the various fasteners.
NOTICE
IMPORTANT INFORMATION: REASSEMBLING DOOR AFTER SERVICING
Be sure insulation is tucked in close to the glass pack. Insulation
should not block the hinge foot openings or be visible through the
openings in the door liner after reassembly.
To avoid stripping the door liner screws or chipping the porcelain,
set a low torque setting when using a drill/driver.
When reinserting the screws which secure the door liner to the
rest of the door assembly, apply pressure to the liner to
compress the insulation inside the door while inserting the center
screw in the bottom edge of the liner first. Continue pressing on
the liner while reinserting the remaining bottom screws. Lastly,
reinsert the (4) screws/o-rings into the face of the door liner.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
7.1.1 Addition of Flat Springs to Door Assembly
Ranges with an FD 9502 and later include a flat spring on each side of the
inner door, between the middle glass bracket and the inner door frame. The
pressure of the flat springs against the brackets prevents the glass from
moving and rattling.
To resolve a report of rattling sounds in the door of a range with an FD prior
to 9502, order Flat Spring Service Kit 00635045. Instructions are included in
the kit, and can also be found in QuickFinder, linked to part number
00635045.
7.1.2
CAUTION
Avoid injury when removing and replacing oven doors.
Be sure range is cool enough for handling.
Position hinges properly (see Figure 4).
Grasp door only by sides, not by the handle.
Do not force door open or closed.
Handle with care–the door weighs approximately 40 lb.
To remove the door...
1. Open door completely.
2. Flip right and left hinge levers back to open, as shown below;
be sure the levers are in the fully open position. (The RH and
LH hinges differ slightly, but operate in the same manner.)
Figure 4 Opening the hinge lever
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Removing and Reinstalling the Door
Page 13 of 36
800 944-2904