Bosch CMG976K 1 Series Manual do utilizador e instruções de instalação - Página 31
Procurar online ou descarregar pdf Manual do utilizador e instruções de instalação para Forno Bosch CMG976K 1 Series. Bosch CMG976K 1 Series 48 páginas.
Imprimir página
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up.
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
Home Connect is not
working properly.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
Cause and troubleshooting
Electronics fault
1.
Disconnect the appliance from the power supply for at least 30 seconds by switching off
the fuse.
Reset the basic settings to the factory settings.
2.
→ "Basic settings", Page 21
There has been a power cut.
Configure the initial configuration settings.
▶
→ "Performing initial start-up", Page 13
Different causes are possible.
Check the notifications that appear on the display.
▶
→ "Displaying information", Page 14
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 32
Demo mode is switched on.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
1.
the fuse box off and then on again.
Switch off demo mode in the basic settings within approx. 5 minutes.
2.
→ "Changing the basic settings", Page 22
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 21
The cleaning function locks the appliance door;
Allow the appliance to cool down until
▶
→ "Pyrolytic activeClean cleaning function", Page 25
The childproof lock locks the appliance door.
Deactivate the childproof lock using the setting ring.
▶
→ "Childproof lock", Page 21
You can switch off the lock in the basic settings.
→ "Basic settings", Page 21
Different causes are possible.
Go to www.home-connect.com.
▶
The drying function is switched on.
You can change the basic setting for the drying function during microwave operation.
▶
→ "Basic settings", Page 21
Observe the information on operating with microwave.
‒
→ "Microwave", Page 16
Basic setting has been changed.
Change the basic setting for the lighting.
▶
→ "Basic settings", Page 21
The LED light is defective.
Call the after-sales service.
▶
→ "Customer Service", Page 32
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
To continue operation, switch the appliance off and on again using
1.
the operation.
If you do not need to use the appliance, press
2.
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Time-setting options", Page 15
lights up in the display.
goes out in the display.
to switch it off.
Troubleshooting en
. Reset and start
31