Bosch Evolution HGS7132UC Manual de conversão - Página 6
Procurar online ou descarregar pdf Manual de conversão para Forno Bosch Evolution HGS7132UC. Bosch Evolution HGS7132UC 32 páginas. Gas free-standing convection range
Também para Bosch Evolution HGS7132UC: Manual de instalação (20 páginas)
Imprimir página
Conversion
Convert Cooktop Valves
for Propane Use
Adjust Broil Burner Ori-
fice
English 4
5. Place the new orifice into the socket then insert each orifice into its respective
threaded hole in the jet holder. Tighten until the orifice stops turning. DO NOT
OVER TIGHTEN.
6. Remove screws to replace burner base, burner cap and burner grate.
Replace screws.
Note: Burner cap must be properly positioned on burner base for burner to
light.
7. Place natural gas orifices in back of card for future conversion back to natural
gas.
1. Verify that all knobs are in the OFF position
2. Remove knobs (pull straight out)
3. Insert 1/8" (or smaller) flat head screwdriver into shaft and turn bypass screw
clockwise until it stops (bypass screw is inside shaft). DO NOT OVER-
TIGHTEN.
Bypass Screw Inside Shaft
5. Replace knobs.
If your range is dual fuel your conversion is complete. Replace the cover
plate and warming drawer and proceed to "Test the Installation" on page 6.
For gas range conversions, continue to next step.
1. Remove oven door (see section "Removing Oven Door" in Use and Care
manual).
2. Remove Broil Burner Assembly. The broil burner assembly is attached to the
top of the oven cavity with 7 screws. Remove screws and gently pull broil
burner assembly straight out being careful not to detach electrical wires.
Place broil burner against back wall of oven cavity.
3. Adjust Broil Orifice. The orifice is located behind the broil burner in the back
oven wall (See Figure 5). Use a 1/2" deep socket driver with 3" minimum
Figure 4: Cooktop Valve Conversion