Bosch FAP-OC 500Series Manual de instalação - Página 7

Imprimir página

Bosch FAP-OC 500Series Manual de instalação

Appliance dimensions

Electrical Installation

The model stated on the front cover is rated at 120V AC,

60 Hz and uses a NEMA 5-15 plug to connect to a

dedicated 120 V microwave circuit.

Model

Connection

HMV5053U

NEMA 5-15

HMV8053U

NEMA 5-15

Electrical Requirements:

a three prong grounded outlet

▯

120 V, 60 Hz, AC only

▯

15 Amp electrical supply with a fuse or a circuit

▯

breaker

This product must be connected to a supply circuit of the

proper voltage and frequency. Wire size must conform to

the requirements of the National Electric Code or the

prevailing local code for this rating. The power supply

cord and plug should be brought to a separate 20-amp

branch circuit single grounded outlet. The outlet box

should be located in the area behind the appliance (see

section Cabinet Dimensions). The outlet box and supply

circuit should be installed by a qualified electrician and

conform to the National Electrical Code or the prevailing

local code.

The voltage used must be the same as specified on this

microwave oven. Using a higher voltage is dangerous

and may result in a fire or oven damage. Using a lower

voltage will cause slow cooking. The manufacturer is not

responsible for any damages resulting from the use of

the oven with any voltage other than specified.

Circuit

Requirements

120 V,

15 Amps

60 Hz

120 V,

15 Amps

60 Hz

Note: Take into account that the front and rear

measurements of the appliance are not identical.

Power Requirements

The outlet must be properly grounded in accordance with

all applicable codes.

It can be installed anywhere inside the cabinet above the

appliance, within reach of the power cord (approx. 24 in).