Bosch FAP-OC 500Series Manual de serviço - Página 12

Imprimir página

Bosch FAP-OC 500Series Manual de serviço

58300000202181 ARA EN B

 Convection fan motor

 Convection ring element *

 Broil element *

 Bake element

 Cooling fan

 Cavity lamp receptacle(s)

If the broil or convection ring element wires are too short to service from the

front, access to the rear of the oven will be required.

5.4 Serviceable from Top

There is limited access to the top front plenum area after sliding the

oven out of the cutout ~10" and removing the access panel on the top

front housing cover.

For unrestricted access to the front plenum area, slide the oven out of

the cutout approximately ~16" and remove the top front housing cover

completely.

The components below are located in the front area of the top

plenum...

 Control module (relay board)

 Daughter board (double ovens only)

 Terminal block

 120VAC receptacle harness and fuse (HBL57M52UCC only)

 CAUTION

When servicing the standard wall oven component of an

HBL57M52UC combination oven, the microwave oven must be

removed in order to access the top plenum area of the

HBL57M52UCC wall oven. To safely remove and reinstall the

microwave, two people are required.

This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.

Novemb er 2018

Figure 5 120VAC receptacle and harness (HBL57M52UCC only)



The 120VAC receptacle snaps into the rear housing cover.

Gain access to the receptacle's electrical fuse and wiring termination

by removing the top front cover.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 500 Series Built-in Wall Ovens

NOTICE

Page 12 of 41

800 944-2904