Bosch FAP-OC 500Series Manual de serviço - Página 26

Imprimir página

Bosch FAP-OC 500Series Manual de serviço

58300000202181 ARA EN B

7. Remove the screw securing the fan to the plenum.

8. Disconnect the wires and remove the fan.

9. Install the new cooling fan and reattach the wires securely.

10. Restore power to the unit and test operation.

11. Reinstall housing cover(s).

12. Slide the unit back into the cutout and reinstall the side trim

pieces.

6.12 Hinge Receivers

To replace the hinge receivers, the oven must be pulled

completely out of the cutout to provide access to the side panel(s).

6.12.1 Replacing the Hinge Receivers

1. Remove power to the oven.

2. Remove the screws securing the right and left side trim pieces

to the cabinetry.

3. Carefully slide the oven out of the cutout to gain access to the

side housing panel(s).

4. On double ovens, remove the corner brackets between the

upper and lower oven.

Figure 36 Double oven corner bracket

This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.

Novemb er 2018

Figure 37 Removing the RH hinge receiver

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 500 Series Built-in Wall Ovens

5. Remove the side panel(s).

6. From the front of the oven, remove the two screws securing

the hinge receiver to the oven.

7. Pull back the side insulation to reveal the hinge receiver and

remove the part.

8. Install the new hinge receiver.

9. Reinstall the oven door and test door operation.

10. Reinstall the side housing cover.

11. Restore power to the unit and test operation.

12. Slide the oven back into the cutout and reinstall the side trim

pieces.

Page 26 of 41

800 944-2904