Bosch FAP-OC 500Series Manual de serviço - Página 33

Imprimir página

Bosch FAP-OC 500Series Manual de serviço

58300000202181 ARA EN B

Model(s)

Option Code

1053

HBL5351UC

HBL5451UC

3053

HBN5451UC

HBL57M52UCC

1153

HBL5551UC

HBL5651UC

3153

HBN5651UC

Table 12 Option codes for 500 series wall ovens

1. Follow the steps in the Accessing Service Mode sections.

2. Advance through the menu until OC: #### is visible

(#### = current option code).

3. Press (+) or (-) to enter editing mode; option code will blink

when editable.

4. Press (+) or (-) to cycle through the available option codes for

the 500 series ovens.

5. Press Clock when the correct option code is displayed; the

code will be saved when exiting Service mode.

Always confirm that the oven and all components are functioning

normally after setting the option code.

7.2.4 Displaying Error Memory

1. Follow the steps in the Accessing Service Mode sections.

2. Advance through the menu until Er: is visible

3. Press (+) or (-) to access the error memory.

If no errors are logged, nonE will be visible.

Errors are displayed in numeric order; the error code (Exxx)

will appear on the left and the error count will appear on the

right of the display. (Example: E206: 003 indicates that error

code 0206 has been logged three times.)

4. Press (+) or (-) to cycle through the error memory.

5. Press Clock to return to the menu screen.

This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.

Novemb er 2018

7.2.5 Testing Relays

Refer to the tables in the Accessing Service Mode section for a list of

relay test menu codes.

7.2.6 Testing Front Panel

The Front Panel Test will confirm that all control inputs are connected

and operating. Both encoder switches and the touch control module

(TCM) are tested.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 500 Series Built-in Wall Ovens

1. Follow the steps in the Accessing Service Mode sections.

2. Advance through the menu until the desired relay test is

visible; Rx: will appear in the display.

The initial displayed state will reflect the current state of the

relay. (Example: R1: 2 should be in the initial display when

selecting the Door Lock Relay Test, indicating the relay is

closed.)

3. Press (+) or (-) to change the state of the relay.

4. Press Clock to return to the menu screen.

1. Follow the steps in the Accessing Service Mode sections.

2. Advance through the menu until FP: appears in the display.

3. Press each key and rotate each knob at least one detent.

When a key is pressed, its identifier will be displayed to the left

of the colon and total input count will be displayed to the right;

encoder switches are identified as S1 (mode) and S2 (temp).

4. When all inputs are detected, the control will reset and enter

normal operating mode.

To exit the test, it must either be successfully completed or the

power must be reset.

Page 33 of 41

800 944-2904