Bosch HB 74S Series Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Forno Bosch HB 74S Series. Bosch HB 74S Series 28 páginas.

Imprimir página

Removing the door covering

The oven door cover can change colour with time. For better
cleaning, we recommend removing the cover.
Fully open the oven door.
1.
Unscrew the oven door cover. To do this, unscrew the right
2.
and left hand side bolts (figure A).
Remove the cover (figure B).
3.
Ensure that the oven door does not close when the cover is
not in place. The inside glass may damage.
Clean the surface using a product specifically for cleaning
stainless steel.
Refit and secure it.
4.
Close the oven door.
5.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the sequence
in which the panels are removed. In order to reassemble the
panels in the correct sequence, use the numbers that appear
on each panel.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
unscrew the left and right screws (fig. A).
Lift the top panel up and pull it out and remove the two small
3.
seals (fig. B).
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the clips from the panel (fig. C).
Remove the seal from the bottom of the panel (fig. D). Pull
5.
the seal and remove it up and out. Pull out the panel.
Pull the lower panel at an angle, upwards and out.
6.
Do NOT unscrew the left and right-hand screws from the
7.
sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
13