Bosch HBA13B120B Manual de instruções de utilização - Página 13

Procurar online ou descarregar pdf Manual de instruções de utilização para Forno Bosch HBA13B120B. Bosch HBA13B120B 24 páginas. Hba13b1 series built-in oven

Imprimir página
Remove the cover (figure B).
3.
$
Make sure that the oven door is not closed while the cover is
removed. The inner panel may be damaged.
Clean the cover with a stainless-steel cleaning agent.
Replace the cover and secure it in position.
4.
Close the oven door.
5.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
0
and zeros
light up in the
display.
%
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
&
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Insert the panel diagonally towards the back (fig. A).
1.
Stick the retaining clips onto the right and left-hand sides of
2.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
$
Insert the uppermost panel diagonally towards the back. The
3.
smooth surface must face outwards.
Put the cover back in place and screw it on.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly fitted.
Problem
Possible cause Remedy/information
The oven does
There is dust on
not heat up.
the contacts.
Error messages
If an error message with
"
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
%
Turn the control knobs back
and forth several times.
appears, press the
0
button. The
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
13