Bosch HBA73B5 0A Series Manual de instruções - Página 15
Procurar online ou descarregar pdf Manual de instruções para Forno Bosch HBA73B5 0A Series. Bosch HBA73B5 0A Series 28 páginas.
Imprimir página
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
Insert the lower panel diagonally towards the back (fig. A).
1.
Insert the centre panel (fig. B).
2.
$
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
and zeros
0
light up in the
display.
The oven does
There is dust on
not heat up.
the contacts.
The oven door
The oven door
cannot be
is locked by
opened. The
L
self-cleaning.
symbol lights
up in the dis-
play.
The oven does
The oven is in
not heat up. The
demonstration
colon in the dis-
mode.
play flashes.
F8 appears in
Automatic
the display.
switch-off has
been activated.
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Wait until the oven has
cooled down and the
q
symbol goes out.
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
button for approx.
D
4 seconds until the colon
lights up constinuously.
Turn the function selector to
the off position.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
&
Insert the uppermost panel diagonally towards the back. The
4.
smooth surface must face outwards.
Put the cover back in place and screw it on.
5.
Attach the oven door.
6.
Do not use the oven again until the panels have been
correctly fitted.
Error messages
If an error message with
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
Error message Possible cause Remedy/information
"‹‚‚
"‹‚†
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Replacing the bulb in the oven ceiling light
L
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
ã=
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).
"
appears, press the
A button was
Press all buttons individu-
depressed for
ally. Check whether any but-
too long or is
tons are jammed, covered
covered up.
up or soiled.
The tempera-
The oven door locks and
ture in the cook-
heating is suspended. Wait
ing
until the oven has cooled
compartment is
down. Press the
too high.
and reset the clock.
0
button. Then
button
0
15