Bdcom S2510-B Manual de instalação do hardware - Página 8

Procurar online ou descarregar pdf Manual de instalação do hardware para Interruptor Bdcom S2510-B. Bdcom S2510-B 19 páginas.

2.3 Requirements for Common Locations

This part describes the requirements for the installation locations.

2.3.1

S2510-B adopts the wall-mount installation mode. The switch has no fan, so an

environment with good ventilation is needed for the heat cooling of the switch.

For location planning and device locating, refer to section 2.3.2 "Location Configuration

Prevention".

2.3.2

The following preventive measures assist you to design the proper environment for the

switch.

Make sure that the workshop is well-ventilated, the heat of electrical devices is



well-discharged and sufficient air circulation is provided for device cooling.

Put the chassis at the place where cool air can blow off the heat inside the



chassis. Make sure the chassis is sealed because the opened chassis will

reverse the cool air flow.

2.3.3

The following content assists you to make a proper cabinet configuration:

Each device on the cabinet gives off heat when it runs. Therefore, the sealed



cabinet must have the heat-discharge outlet and the cooling fan. Do not put the

devices too close, avoiding bad ventilation.

When you install the chassis at the open cabinet, prevent the frame of the cabinet



from blocking the airway of the chassis.

Ensure that nice ventilation is provided for the devices installed at the bottom of



the cabinet.

The clapboard separates exhaust gas and inflow air, and boost the cool air to



flow in the chassis. The best location of the clapboard is decided by the air flow

mode in the chassis, which can be obtained through different location tests.

Take proper measures to help persons who are hit by the disaster. Artificial

respiration is needed if necessary.

Seek for medical help, or judge the loss and seek for available help.

S2510-B Hardware Installation Manual

- 6 -