Error
code
E11
Fill time too long.
E13
Water leak in tub or air leak in air bell.
E21
Water not pumping out fast enough.
E31
Electronic pressure switch failure.
E32
Pressure sensor calibration problem.
E35
Pressure sensor indicates water overfill.
E38
Air trap clogged.
E41
Control board thinks the door switch is open.
E42
Door lock device failure
E44
Door closed sensing failure.
E45
Line door sensing failure.
E46
Door command sense.
E49
Door incngruence between door line and door sense.
E52
Bad signal from tacho generator.
E53
Low Voltage to Motor Control Board.
E54
Over speed.
E55
Under speed.
E57
High current on inverter.
E58
High current on motor phase.
E59
No tacho signal for 3 seconds.
E5A High temperature on heat sink caused by overloading.
E5C High Voltage experienced by MC.
E5D Communication problem.
E5E Communication problem.
E5F
MC is continuously resetting.
E67
Heater sensing relay failure.
E68
Current leakage to ground on heater or fuse opened.
E69
Heating element relay failure.
E71
Drum water NTC failure. (Tub heater)
E74
Wash temperature does not increase.
E91
Communication error between UI board and main control board.
E92
UI_MB communications error
E93
Console or Main Board control problem.
E94
Main Board control problem.
E95
Communication problem between microprocessor
and external EEPROM.
E97
Console or Main Board control problem.
E98
Console control problem.
E9F
Communication protocol
EA1 Power supply frequency out of limits
EA2 Power supply voltage too high
EA3 Power supply voltage too low
EA5 Main Voltage sensing failure
EAE Line safe relay sensing failure
EF1
Clogged drain pump.
EF2
Too much soap.
EF5
Incorrect water temperature.
EF8
Key Stuck
Error code chart
Fault condition
Refer to test (1).
Refer to test (2).
Refer to test (3).
Refer to test (4).
Refer to test (4).
Refer to test (5).
Refer to test (5).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (6).
Refer to test (7).
Refer to test (15).
Refer to test (9).
Refer to test (9).
Refer to test (8).
Refer to test (8).
Refer to test (9).
Refer to test (8).
Refer to test (12).
Refer to test (10).
Refer to test (10).
Refer to test (10).
Refer to test (13).
Refer to test (13).
Refer to test (13).
Refer to test (14).
Refer to test (14).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (10).
Refer to test (10)
Refer to test (12).
Refer to test (12).
Refer to test (12).
Refer to test (12).
Refer to test (12).
Unclog the drain pump.
Advise customer to reduce the amount
of soap they are using.
Refer to test (16)
Check all buttons
3
Check
Imprimir página