Electrolux EW 1042 S Folheto de instruções - Página 7

Procurar online ou descarregar pdf Folheto de instruções para Máquina de lavar roupa Electrolux EW 1042 S. Electrolux EW 1042 S 22 páginas.

Imprimir página

Water inlet

Connect the water inlet hose to a tap with a

thread.

The other end of the inlet hose which connects

to the machine can be turned in any direction.

Simply loosen the fitting, rotate the hose and

retighten the fitting, making sure there are no

water leaks.

The inlet hose must not be lengthened. If it is

too short and you do not wish to move the tap,

you will have to purchase a new, longer hose

specially designed for this type of use.

Water stop device

The inlet hose is provided with a water stop

device, which protects against damage caused

by water leaks in the fill hose which could

develop due to natural ageing of the hose. This

fault is shown by a red sector in the window

«A».

Should this occur, turn the water tap off and

refer to your Service Agent to replace the hose.

Water drainage

The end of the drain hose can be positioned in

three ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the machine is

emptying.

This could be done by tying it to the tap with a

piece of string or attaching it to the wall.

In a sink drain pipe branch. This branch must

be above the trap so that the bend is at least 60

cm above the ground.

Directly into a drain pipe at a height of not

less than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the drain

pipe must be larger than the outside diameter of

the drain hose.

The drain hose must not be kinked. Run it along

the floor; only the part near the drainage point

must be raised.

P0351

P0352

P0022

P0023

P0021